Working Stress Method
in this method, it is assumed that concrete is elastic. The permissible stress for concrete and steel is not allowed to exceed the limit. Permissible stress is multiplied by the factor of safety to account for deviation in properties of materials. IS code recommends using the factor of safety 3,1.78 for concrete and steel, respectively.
Assumption
1- Section remains plane before bending and after bending
2- Bond between steel and concrete is perfect within elastic limit.
3- Concrete has no tensile strength.
4- Stress in Concrete varies linearly
Drawbacks of working stress
1- Concrete is not elastic
2- Difficult to account for shrinkage and creep effects.
3- Stress are factored, not load, so uncertainty for the load is not accounted.
Value of modules ratio, (m)
As per IS 456
m = 280/(3 σcbc)
ANALYSIS OF A RCC BEAM FOR FLEXURE
Stress behaviour
There are three types of sections.
(i) Under reinforced section
- Actual depth of neutral axis (Xa) < critical depth (xc)
- At the maximum bending moment that can be allowed.
- stress in concrete ⇒ Ca < σcbc
- stress in steel ⇒ ta = σst
(ii) Over reinforced section
- Actual depth of neutral axis (Xa) >critical depth (xc)
- At moment of resistance
- stress in concrete ⇒ Ca = σcbc
- stress in steel ⇒ ta < σst
(iii) Balanced section
- Actual depth of neutral axis (Xa)=critical depth (xc)
- At moment of resistance,
- stress in concrete ⇒ Ca = σcbc
- stress in steel ⇒ ta = σst
Note : For balanced section.
xc = k.d
k= [mc/(t+mc)]
*****
If you are preparing for ESE/ GATE or other PSU Exams (Civil Engineering), then avail Online Classroom Program for ESE and GATE CE:
Online Classroom Program for ESE/GATE CE
You can avail of BYJU'S Exam Prep Test Series specially designed for all Civil Engineering Exams:
BYJU'S Exam Prep Test Series ESE/GATE CE
Thanks
All the Best
Comments
write a comment