Week e

A 1- Φ diode Bridge rectifier is required to supply a dc output voltage of 120 V to a load  resistance R = 6Ω. Determine the transformer rating required for this configuration in KVA?

A single-phase full bridge diode rectifier is supplied form 230 V, 50 Hz. The load have R = 10 Ω and a large inductance so as to render the load current constant. Then determine the rms value of diode current?

A 120V, 50Hz ac voltage is applied to the primary of 5:1 step up transformer whose secondary is centre tapped allowing a load of 1KΩ to be connected for a full wave rectification using two diodes. The lowest value of ripple frequency in Hz ?

Consider the rectifier circuit shown below. The supply have 230V, 50Hz, and the load resistance having the value of R = 10Ω than find the RMS value of current flows through diode D₁?

In a single-phase full wave diode bridge rectifier the diodes have a reverse recovery time of 40 μs. For an AC input voltage of 230 V, Determine the reduction in average output voltage due to reverse recovery time for a supply frequency of 2.5 KHz?

In the single-phase diode bridge rectifier shown in figure, the load resistor is R = 50 Ω. The source voltage is V = 200 sin(ωt), where ω = 2π × 50 rad/sec. The power dissipated in the load resistor R is

Analysis of voltage waveform of a single-phase bridge converter shows that it contains x % of 6^th harmonic. The 6^th harmonic content of the voltage harmonic content of the voltage waveform of a 3-phase bridge converter would be