Time Left - 08:00 mins
Strength of Materials Quiz 1
Attempt now to get your rank among 1262 students!
Question 1
Factor of safety is the ratio of
Question 2
For an element under equal and opposite 2D-normal stresses , then radius of Mohr circle is
Question 3
The shear associated with change of bending moment along the span is known as:
Question 4
The working stress of a material is expected to be
Question 5
What change is observed in the BMD and SFD
In the case of an external couple acting at a point in a beam?
In the case of an external couple acting at a point in a beam?
Question 6
The moment required to rotate the near end of a prismatic beam, through the unit angle, without transition (the far end being fixed and near end is hinged) is given by,
Question 7
For a single angle section, the area of outstanding and connected legs are 450 mm2 and 300 mm2. What will be the net area of the section?
Question 8
Which one of these is not a method to obtain deflection of beams?
Question 9
A simply supported beam of span l, carries uniformly y distributed load per unit length over the whole span. Flexural rigidity of beam, is EI. The maximum deflection of the beam is given by
Question 10
A solid shaft is subjected to torsion causing maximum shear stress. The radius of the shaft is 35 mm. If the shaft is made hollow with internal diameter 20 mm, then the maximum torque that can be applied is ____ of the previous.
- 1262 attempts
- 5 upvotes
- 18 comments
Tags :
ESE & GATE CEGeneralMay 2ESE & GATE CE