Time Left - 06:00 mins

Steel Design Booster Quiz-7

Attempt now to get your rank among 131 students!

Question 1

In a built-up section carrying tensile force, the flanges of two channels are turned outward

Question 2

If the sides of a slab simply supported on edges and spanning in two directions are equal, the maximum bending moment is multiplied by ______________.

Question 3

If the pitch is 6 cm and rivet value is 4 tonnes, the number of rivets required for a riveted connection carrying an eccentric load of 15 tonnes at 30 cm from the centre line is _____.

Question 4

The gross diameter of rivet (hole) for a rivet with nominal diameter of 27 mm is

Question 5

In a double riveted double-covered butt joint, the strength of the joint per pitch length in shearing the rivets P_d and strength of one rivet in single riveted single covered but joint in shear P_s are related as:

Question 6

In a truss girder of a bridge, a diagonal consists of mild steel flat 400 I.S.F. and carries a pull of 80 tonnes. If the gross diameter of the rivet is 26 mm, the number of rivets required in the splice is

Question 7

According to the Unwin's formula, if t is the thickness of the plate in mm, the nominal diameter of the rivet is

Question 8

Cold driven rivets range from _____________.

Question 9

As per IS 800:2007 maximum effective slenderness ratio for a member carrying compressive loads resulting from dead loads and imposed loads will be:

Question 10

If the value of a 20 mm diameter rivet in a lap joint connecting two plates 10 mm and 15 mm thick, then bearing strength of one rivet is

(Take and)

131 attempts
0 upvotes
1 comment

Tags :

AE & JE Exams

Jun 5AE & JE Exams