Time Left - 08:00 mins
SSC JE 2019-20: Technical Quiz 45
Attempt now to get your rank among 1015 students!
Question 1
The figure (all dimensions are in mm) below shows an I-section of the beam. The shear stress at point P (very close to the bottom of the flange) is 12 MPa. The stress at point Q in the web (very close to the flange) is :
Question 2
If cross sectional area of each member is ‘A’ and the modulus of elasticity of material is ‘E’. then strain energy in the member XY of a truss, shown below, is
Question 3
Potassium dichromate is used for measuring
Question 4
Runoff cannot be determined by
Question 5
Disadvantages of direct shear test:
1. Drainage condition cannot be controlled.
2. Pore water pressure cannot be measured.
3. unsuitable for freely draining soil.
Which of these statements is/are correct?
Question 6
What is the thickness (inches) of the one brick wall made up of traditional brick?
Question 7
What is the discharge(m3/s) from circular pipe having the diameter of 0.5 m and average velocity of flow of 10 m/s?
Question 8
The plan of a building is in the form of a rectangle with centre line dimensions of outer walls as The thickness of the wall in super structure is 0.30 m. What is the floor area of the building?
Question 9
The gross diameter of a rivet is the diameter of _____.
Question 10
The section of the tunnel adopted perfectly in lieu of construction and maintenance in hard rock tunnels, where the risk of roof failure or collapse caused by external pressure from water, or from loose or unstable soil conditions on tunnel lining is perfectly non-existent is
- 1015 attempts
- 4 upvotes
- 8 comments
Tags :
ESE & GATE CEGeneralJun 14ESE & GATE CE