Time Left - 15:00 mins
RVUNL EE Analog Electronics Revision Quiz
Attempt now to get your rank among 160 students!
Question 1
Match List-I with List-II and select the correct answer using the code given below the Lists:
List-I
A) Tuned circuits.
B) Voltage reference.
C) High frequency.
D) Current controlled attenuator.
List-II
1) Schottky diode
2) Varactor diode.
3) PIN diode.
4) Zener diode.
List-I
A) Tuned circuits.
B) Voltage reference.
C) High frequency.
D) Current controlled attenuator.
List-II
1) Schottky diode
2) Varactor diode.
3) PIN diode.
4) Zener diode.
Question 2
Which one of the following oscillators is used for the generation of high frequencies?
Question 3
In a voltage regulator, zener diode is.
1) Connected in series with filter output.
2) Forward biased.
3) Connected in parallel with filter output.
4) Reverse biased.
Which of the above are correct?
1) Connected in series with filter output.
2) Forward biased.
3) Connected in parallel with filter output.
4) Reverse biased.
Which of the above are correct?
Question 4
In the practical oscillator circuit, which one of the following limits the amplitude of the oscillations?
Question 5
The pinch-off voltage VP= -6 V for a P- channel JFET. If VGS = + 2V. what is the value of VDS at which it will enter into the saturation region?
Question 6
In a sinusoidal oscillator, sustained oscillations will be produced only if the loop gain (at the oscillation frequency) is
Question 7
Consider the following statements in respect of a CC amplifier.
1) It performs a resistance transformation from low to high resistance.
2) Its current gain is close to unity.
3) Its current gain is close to zero
4) Its frequency range is higher than that of a CE-stage.
Which of the statements given above are correct?
Question 8
The ideal op-amp has
Question 9
Operating point shift can occur in an amplifier due to which one of the following?
Question 10
Which one of the following statements regarding slew rate is correct?
Question 11
Which of the following will be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?
1) Its gain will increase.
2) Its stability will increase.
3) Its gain will decrease.
4) its stability will decrease.
Select the correct answer from the codes given below:
1) Its gain will increase.
2) Its stability will increase.
3) Its gain will decrease.
4) its stability will decrease.
Select the correct answer from the codes given below:
Question 12
For the circuit show below the value if i0 is-
- 160 attempts
- 0 upvotes
- 0 comments
Tags :
AE & JE ExamsMay 16AE & JE Exams
