Time Left - 12:00 mins
GATE CE 2022 Toppers Quiz 6
Attempt now to get your rank among 168 students!
Question 1
When a circular rod of diameter 'd' welded to a rigid plate by a circular fillet weld of size 's' is subjected to a twisting moment 'T',then the maximum shear stress is given by
Question 2
For the activity 3-4 shown in the figure, the independent float (in days) is
Question 3
Particulate matter (fly ash) carried in effluent gases from the furnaces burning fossil fuels are better removed by
Question 4
In a beam of length L, four possible influence line diagrams for shear force at a section located at a distance of L/4 from the left end support (marked at P, Q, R and S) are shown below. The correct influence line diagram is
Question 5
A beam AB is supported on an elastic column BC and is loaded as shown in figure. Joint B is rigid.
The rotation of the joint B is
The rotation of the joint B is
Question 6
At a certain section of a shaft 80 mm in diameter there is a bending moment of 3.5 kNm and a twisting moment of 5 kNm. If the Poisson’s ratio of material is 0.28 then the magnitude of stress acting alone that can produce the same maximum strain will be
Question 7
During the subsurface investigations for design of foundations, a standard penetration test was conducted at 4.5m below the ground surface. The record of number of blows is given below.
Assuming the water table at ground level, soil as fine sand and correction factor for overburden as 1.0, the corrected ‘N’ value for the soil would be
Assuming the water table at ground level, soil as fine sand and correction factor for overburden as 1.0, the corrected ‘N’ value for the soil would be
Question 8
A square column section of size 350 mm × 350 mm is reinforced with four bars of 25 mm diameter and four bars of 16 mm diameter. Then the transverse tie reinforcement would be
- 168 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE CEGeneralDec 17ESE & GATE CE