Time Left - 12:00 mins
GATE CE 2022 Toppers Quiz 10
Attempt now to get your rank among 137 students!
Question 1
In a CPM network the activity is non critical if
Question 2
Calculate the shear strength of a ISWB section of height 350 mm, breadth 200 mm, thickness of web 8 mm. The yield strength of steel in 250 MPa.
Question 3
The biomass growth and food utilization curve is shown as below:
Among the four phases A, B, C and D, the endogenous phase is
Among the four phases A, B, C and D, the endogenous phase is
Question 4
A fluid is flowing with the following velocity profile
If the flow is 2D and incompressible then find the value of
If the flow is 2D and incompressible then find the value of
Question 5
A rigid beam AB of length 2L is hinged at A and supported by linear elastic springs (having stiffness 2k and k) at point (1) and (2) and an inclined load acts at mid point between (1) and (2) as shown. The force in spring (1) and (2) is
Question 6
A 200 mm diameter pipe conveys water in turbulent flow regime. The friction factor has been estimated as 0.01 for this flow. If the centre line velocity is measured as 3.0 m/s, then the discharge (in l/s) in the pipe will be
Question 7
Determine the ultimate bearing capacity of a strip footing 2.0 m wide at a depth of 1.5 m resting on a moist soil having cohesion of 20 kN/m2 and angle of internal friction of 30 °. The water table lies at a depth of 0.75m. Take γ = 18 kN/m3, γ’ = 11.19 kN/m3, Nc = 37.2, Nq = 22.5 and Nγ = 19.7
Question 8
A 30 cm diameter sewer is laid at a slope of 0.004 and is designed to carry a discharge at a depth of 15 cm with manning’s n = 0.012. The design discharge is
- 137 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE CEGeneralDec 22ESE & GATE CE