Time Left - 15:00 mins

GATE 2024 II Fluid Mechanics & Machinery II Rank Booster Quiz 7

Attempt now to get your rank among 20 students!

Question 1

A fluid entire a circular pipe with free stream velocity of 5 m/s. The average velocity (in m/s) in developed region of flow is

Question 2

In a laminar flow between two parallel plates with a separation distance of 6 mm, the centre line velocity is 1.8 m/s. The velocity (in m/s) at a distance of 1 mm from the Boundary is _________.

Question 3

The intensity of turbulence refers to

Question 4

In laminar flow between two parallel plates, the slope of hydraulic gradient line was found to be 0.05. If the discharge remains the same but the viscosity increases by 50% ,the value of new slope of hydraulic gradient line will be.

Question 5

The relation

is valid for

Question 6

Water flows at a steady mean velocity of 2.5m/s through a 45 mm diameter pipe slopping upwards 45 ° to the horizontal. At a section some distance downstream of the inlet the pressure is 800 kPa and at a section 30 m further along the pipe the pressure is 480 kPa. Determine the average shear stress at the wall of the pipe.

Question 7

A rough pipe of diameter 0.1 m carries water at 20˚C at the rate of 50 liters/sec. If the average height of roughness projection on the pipe surface 0.15 mm. Determine the friction factor.
Take properties of water at 20˚C,

20 attempts
0 upvotes
0 comments

Tags :

ESE & GATE ME Fluid Mechanics & Machinery

Nov 14ESE & GATE ME