GATE 2022 Toppers Weekly Quiz 3

What is the ratio of the fuel consumption in L/hr for a petrol engine and a diesel engine?

A rolled I-Section is given in figure below. The thickness of flanges and web are 10 mm. If Fe 410 grade plates are used, find the maximum design shear strength (in KN) that the section can take as per IS : 800–2007?

If design overrate flow of a settling tank is and the design flow is . Then surface area of tank is

In a field test of a formation having a porosity of 25% the hydraulic gradient was found to be 0.04, and the velocity of a tracer added to the groundwater was 6m/hr.

The permeability of the aquifer is

A field of 450 hectares is to be irrigated for a particular crop having 90 days base period. The total depth of water required by the crop is 150 cm. Calculate the duty of water (in hectare per cubic meter).

Concrete is expanded due to condensation. Assume it is a plain concrete. The minimum cement required is “a” kg/m³. If R.C.C. is used in place of plain concrete, then “b” g/m³ cement is needed. The ratio of ________.

A 86 kN concentrated load was applied over the ground surface. Where value of influence factor is 0.At a depth of 6 m i.e directly below the point load the increase in vertical stress is ____kN/m²

A column section ISHB 350@661.2 N/m carries a factored axial compressive load of 20000 kN and factored bending moment of 100 kN-m the thickness of the base plate is 30mm. Calculate moment capacity of the base plate for 410-grade steel?

In case of Tornado, when we study about the air mass which can be explained as

Which of the air pollutants are primary pollutants