Time Left - 15:00 mins
GATE 2022 : Power Electronics Quiz 6
Attempt now to get your rank among 200 students!
Question 1
A single quadrant chopper is feeding a separately excited DC motor from 400V DC. If the motor constant is 1V-sec/rad, armature resistance 2Ω and duty ratio of 0.6 then the speed of motor at 5 Nm torque is:
Question 2
In the below figure shows a chopper operating from 150 V DC input the duty ratio of switch is 0.4. The average output voltage of the chopper will be
Question 3
A Boost converter is shown in the following circuit.
If Vdc = 20 V, V0 = 50 V, R = 50 Ω, L = 20 μH and ∝ = 0.5
Then the converter will operate at a switching frequency (in kHz)
Question 4
In the following circuit the ideal switch S is operating at 10 KHz. The circuit is operated in steady state at the boundary of the continuous and discontinuous, the critical resistance is.
Question 5
In the following circuit, MOSFET Q is switched at 100 KHz with a duty ratio of 0.5 . MOSFET is having an ON resistance of 20Ω when it is ON (Consider the case of boundary of continuous and discontinuous condition).
The average conduction Loss in MOSFET is.
Question 6
A voltage commutated chopper is gives below. The chopper duty ratio is 50%. The load current remains contact 10 A assuming the input voltage to be 190 V and device to be ideal. Maximum value of current through capacitor is
- 200 attempts
- 1 upvote
- 0 comments
Nov 25ESE & GATE EE