Time Left - 15:00 mins
GATE 2022 ME: Production Engineering Quiz - 2
Attempt now to get your rank among 457 students!
Question 1
A brass billet is to be extruded from its initial diameter of 100 mm to a final diameter of 50 mm. The working temperature of 700 °C and the extrusion constant is 250 MPa. The force required for extrusion is
Question 2
Calculate the punch size in mm, for a circular blanking operation for which details are given below
Size of the blank 25 mm
Thickness of the sheet 2 mm
Radial clearance between punch and die 0.06 mm
Die allowance 0.05 mm
Question 3
In a rolling process, thickness of a strip is reduced from 4 mm to 2 mm using 300 mm diameter rolls rotating at 100 rpm. The velocity of the strip (in m/sec) at the neutral point is __________.
Question 4
A block made of perfectly plastic material with a yield stress of 260 MPa in simple tension has the diameter 200 mm × 100 mm × 150 mm (b × h × w) at one instant during plane strain forging. Assuming there is sticking friction, the peak pressure will be
Question 5
In a slab rolling operation, the maximum thickness reduction 
is given by 
, where R is the radius of the roll and µ is the coefficient of friction between the roll and the sheet. If 
, the maximum angle subtended by the deformation zone at the centre of the roll (bite angle in degrees) is_____
is given by , where R is the radius of the roll and µ is the coefficient of friction between the roll and the sheet. If , the maximum angle subtended by the deformation zone at the centre of the roll (bite angle in degrees) is_____Question 6
Which of the following assumption are taken during forming in slab method?
- 457 attempts
- 0 upvotes
- 0 comments
Jul 17ESE & GATE ME
