Time Left - 12:00 mins
ESE 2022 ME - Technical Quiz 13
Attempt now to get your rank among 368 students!
Question 1
In a pipe flow, the pressure (P) of fluid varies according to the relation P = 4x2 + 3x kPa. Find the shear stress at wall for that pipe of diameter 500 mm at x = 2m.
Question 2
A De laval turbine has a blade velocity of 300 m/s. The steam enters the turbine at a mass flow rate of 1 Kg/s at a Nozzle angle of 20° and leaves the nozzle at a speed of 800 m/s. Calculate the power developed if the blade coeff. is 0.8 (Assume symmetrical blading)
Question 3
Entropy of wet stream (1 kg) is given by
Question 4
A solid circular shaft of diameter 100 mm is subjected to an axial stress of 50 MPa. It is further subjected to a torque of 10 kNm. The maximum principal stress experienced on the shaft is closest to
Question 5
Nitriding, a heat treatment process, will______.
Question 6
Which of the below can be studies by Wear debris analysis ?
1) Rubbing wear
2) Cutting wear
3) Rolling fatigue
4) combined rolling and sliding wear
5) Severe sliding wear
Question 7
In Equipment and process improvement, the manpower losses will not include:
Question 8
Heat transfer rates in drop wise condensation may be as much as thanin film condensation
Question 9
Which of the following statements is incorrect ________.
Question 10
A centrifugal pumps having efficiency of 75%, is used to deliver 2000 L/min. of water at 20o C when the brake power is 25HP. The rise in pressure (in kPa), is
- 368 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE MEGeneralSep 29ESE & GATE ME