Time Left - 18:00 mins
BARC Full Syllabus Test 22
Attempt now to get your rank among 178 students!
Question 1
A circuit consists of two clocked JK flip-flops connected as follows 
and 
. Each flip-flop receives the clock input simultaneously. The circuit acts as a
and . Each flip-flop receives the clock input simultaneously. The circuit acts as a Question 2
The following sequence of instructions is executed by an 8085 microprocessor:
1000 LXI SP, 27FF
1003 CALL 1006
1006 POP H
The contents of the stack pointer (SP) and the HL register pair on completion of execution of these instructions are.
1000 LXI SP, 27FF
1003 CALL 1006
1006 POP H
The contents of the stack pointer (SP) and the HL register pair on completion of execution of these instructions are.
Question 3
Which device is suitable for higher order RF frequency multiplier/
Question 4
In a PID controller as shown, what will be the closed loop transfer function?
Question 5
The input resistance 
of the circuit in figure is
of the circuit in figure is Question 6
For the circuit shown β = 30, VBE = 0.7 V, calculate the required value of Vi to get V0 = 6V
Question 7
For the ideal OP-amp based circuit shown below, find the output waveform for the input waveform shown below.
Question 8
The E-MOSFET is normally-off MOSFET when:
Question 9
Which one of the following statements regarding slew rate is correct?
Question 10
In a linear system, an input of 5sin
t produces an output of 10cos
t. The output corresponding to input 10cos
t will be equal to:
t produces an output of 10cost. The output corresponding to input 10cost will be equal to: Question 11
Consider the root locus plot shown in below:
S1: Adding a zero between s = –1 and s = –2 would move the root locus to the left.
S2: Adding a pole at s = 0 would move the root locus to the right.
Which of the following is the correct answer?
Question 12
Energy of signal n u[n] is
Question 13
An open loop transfer function with unity feedback system is
The value of K at one of the break-away or break-in points of the root locus for the above system.
Question 14
The transconductance gm of the transistor used in the CE amplifier shown in the below circuit operating at room temperature is.
Question 15
Consider an n-channel depletion-mode MOSFET has parameters VTN = –2V and kn = 80
A/V2. The drain current is
A/V2. The drain current is
ID = 1.5mA at VGS = 0 and VDS = 3V. Then W/L ratio is ______
- 178 attempts
- 0 upvotes
- 0 comments
Tags :
ESE & GATE ECGeneralSep 17ESE & GATE EC
