Time Left - 08:00 mins
SSC JE 2019 - 20 technical Quiz 43
Attempt now to get your rank among 951 students!
Question 1
Magnetic forming is an example of
Question 2
Metallic powders can be produced by ____.
Question 3
In a strained material one of the principal stresses is twice the other. The maximum shear in the same cases is . Then, what is the value of the maximum principal stress?
Question 4
The knocking tendency in compression ignition engines increases with
Question 5
How are the velocity coefficient Cv, the discharge coefficient Cd and the contraction coefficient Cc of an orifice related?
Question 6
Bearings are compared based on their load carrying capacity, therefore the bearing whose load carrying capacity is independent of speed is;
Question 7
A cornot engine operates between and . If the engine produce 300 kJ of work, what is the magnitude of entropy change during heat addition?
Question 8
In order to have a low by-pass factor of a cooling coil, the fin spacing and the number of tube rows should be
Question 9
The ‘NTU’ (Number of transfer Units) in a heat exchanger is given by which one of the following?
where, U = Overall heat transfer coefficient
C = Heat capacity
E = Effectiveness
A = Heat exchange area
where, U = Overall heat transfer coefficient
C = Heat capacity
E = Effectiveness
A = Heat exchange area
Question 10
In a reaction turbine the enthalpy drop in a stage is 60 units, the enthalpy drop in the moving blades is 32 units. The degree of reaction is _________.
- 951 attempts
- 1 upvote
- 11 comments
Tags :
ESE & GATE MEGeneralJan 21ESE & GATE ME