Time Left - 18:00 mins
BARC EE : Full Syllabus Test - 7
Attempt now to get your rank among 286 students!
Question 1
On which of the following factors does hysteresis loss depend?
1) Flux density
2) Frequency
3) Thickness of lamination
4) Time
Select the correct answer using the code given below:
1) Flux density
2) Frequency
3) Thickness of lamination
4) Time
Select the correct answer using the code given below:
Question 2
An inductance having and a capacitance having are connected in parallel across a supply. The current drawn from the supply is?
Question 3
The time interval needed for a surge to travel to the end of a 600 km long overhead transmission line is
Question 4
An 8-bit DAC uses a ladder network. The full-scale output voltage of the converter is +10V. The resolution expressed in percentage and in volts is, respectively
Question 5
An initially relaxed RC circuit with and is switched on to a step voltage of 10V. The voltage across capacitor after 2sec will be?
Question 6
For the circuit shown, maximum value of capacitor current is ________A.
Question 7
The edge triggered interrupts in 8085 is:
Question 8
What is the maximum output voltage of a 3-phase bridge rectifier supplied with line voltage of 230 V.
Question 9
A junction field effect transistor:
Question 10
The pole-zero configuration of a transfer function is shown below.
The value of the transfer function at s = 2 is found to be 4. The transfer function is
Question 11
The spectrum is the range (550 to 1650)kHz is allocated for AM radio broadcasting and the spectrum is shored for different AM radio station using frequency division multiplexing (FDM). If the message signal of each AM radio station is band-limited to 5 kHz, then the maximum number of different AM radio stations that can be enjoyed by a listener will be equal to
Question 12
If ξ = sin θ, then maximum peak overshot at θ = 45° will be:
Question 13
The efficiency of a 25KVA, 5000/600V 1 – ϕ transformer at unity p.f. is 96% at rated and half rated load, then is equal to
Question 14
Non-uniform quantization is preferred for
Question 15
The generated power of two plants is given by and . If the lost coefficients of two plants are given as B11 = 0.001, B22 = 0.002, the power lost will be
- 286 attempts
- 0 upvotes
- 1 comment
Tags :
ESE & GATE EEGeneralSep 4ESE & GATE EE