Time Left - 08:00 mins

SSC JE 2019-20: Technical Quiz 77

Attempt now to get your rank among 790 students!

Question 1

Force in member BD is (take tensile as positive)

Question 2

Distribution factor of OA, OB, OC and OD are respectively

Question 3

The maximum bending moment at the left quarter point of a simple beam due to crossing of UDL of length shorter than the span in the direction left to right would occur after the load had just crossed the section by

Question 4

Force in member BC is (take +ve tension)

Question 5

If an identical cube is retrained in 2 direction then stress developed in both directions will be (σ_x and σ_y respectively)

Given :σ_z =σ,

Question 6

Draw SFD for given beam

Question 7

A single supported rectangular beam is uniformed loaded. Find maximum bending stress at mid portion

Question 8

For circular cross-section, Ratio of maximum shear stress to any shear stress is

Question 9

A metal was tested in the lab for its yield strength and its ultimate strength. Its yield strength was found to be 50 N/mm² while its ultimate strength was 4 times its yield strength. If the strain at rupture was 0.25 then the modulus of toughness of the metal will be

Question 10

A simply supported beam of length L is applied with a varying load of

where L is the length of the span and x is the distance from the free end, then as the value of x increases

790 attempts
4 upvotes
5 comments

Tags :

ESE & GATE CE General

May 19ESE & GATE CE