Time Left - 08:00 mins
SSC JE 2019-20 Technical Quiz 55
Attempt now to get your rank among 745 students!
Question 1
Centrifugal Methods of reconditioning transformer oil is effective for removal of ___________.
Question 2
Determine the current (in A) through a 60 cm long solenoid when the solenoid has 400 turns and the value of magnetic field at the centre of the solenoid is 6 mT.
Question 3
Which of the following is the most commonly used measurement unit for a typical 1-phase energy meter?
Question 4
What will be the permeance (in H) of a coil, when the flux through the coil is 50 Wb and the value of produced mmf is 25 Amp-turns?
Question 5
The lamp shown in the picture is switched on. From the moment of switching on, how long does it take for the lamp to glow?
Question 6
A parallel RLC circuit is being supplied by a DC source as shown in the figure below. What is the value of current following through the capacitor (in A)?
Question 7
Determine the intensity of magnetization (in Nm) of a magnet when the pole strength of the magnet is 30 A-m and the pole of the magnet is 2 sq. m.
Question 8
A silver and zinc voltameters are connected in series. A current of amperes is passed through them for time If gram of zinc is liberated, then the mass of silver deposited is nearly
Question 9
The life of the positive plates of a lead-acid cell is roughly…………………that of negative plates.
Question 10
In two wattmeter method of power calculation of a 3-phase balanced star connected system, what is the power factor of the system, if both the wattmeters show same the positive reading?
- 745 attempts
- 1 upvote
- 9 comments
Tags :
ESE & GATE EEGeneralApr 27ESE & GATE EE