Time Left - 08:00 mins
SSC JE 2019 - 20 technical Quiz 38
Attempt now to get your rank among 1191 students!
Question 1
Which one of the following is the major alloying element in Invar?
Question 2
At what depth below the free surface of oil having a density of 784 kg/m3 will the pressure be very nearly equal to 1 bar ?
Question 3
At a section of a beam, shear force is F with zero BM. The cross-section is square with a side ’a’. Point A lies on the neutral axis and point B is mid-way between neutral and top edge, i.e. at distance a/4 above the neutral axis. If and denote shear stresses at points A and B, then what is value of /?
Question 4
The effectiveness of a fin will be maximum in an environment with
Question 5
In which of the following welding process flux is used in the form of granules?
Question 6
Which of the following is not an example of higher pairs?
Question 7
In an axial flow compressor, stalling is the phenomenon of
Question 8
In gas cycle refrigeration system, an expander replaces the throttle valve of a vapour compression system, because
Question 9
a fillet weld is loaded parallel to its length by a load P. If the weld leg is h, the average shear stress on the throat area is
Question 10
Measurement of temperature is based on which law of thermodynamics?
- 1191 attempts
- 1 upvote
- 10 comments
Tags :
ESE & GATE MEGeneralJul 17ESE & GATE ME