Time Left - 08:00 mins
SSC JE 2019-20: Technical Quiz 3
Attempt now to get your rank among 1328 students!
Question 1
The value of wobble correction factor varies from
Question 2
The number of unit hydrographs needed to produce S-curve is
Question 3
The maximum error (mm) on the drawing should not be greater than _________
Question 4
Which of the following bonding is responsible to combine the silica-gibsite sheet in kaolinite clay mineral?
Question 5
The cement becomes useless if its absorbed moisture content exceeds
Question 6
In which of the following unit kinematic viscosity of fluid is measured?
Question 7
Which of the following dimension represents the pressure?
Question 8
Calculate the cost of the plastering required for a wall of 4 m long, 3.5 m high and 300 mm thick, if the rate of plastering is Rs. 12 per square meter. (Assume both side plastering is done)
Question 9
The least suitable water for irrigation is
Question 10
Creep losses are generally_______ of initial prestressing force.
- 1328 attempts
- 1 upvote
- 7 comments
Tags :
ESE & GATE CEGeneralAug 23ESE & GATE CE