Time Left - 08:00 mins
SSC JE 2019-20 Technical Quiz 16
Attempt now to get your rank among 666 students!
Question 1
An orthogonal machining operation is to be performed having depth of cut of 2 mm and feed rate of 2.6 mm/rev. if the spindle is rotating at a speed of 26 m/sec. find the power ( in kW) required at the motor for such application assuming no power loss during transmission. The material strength is 12 Mpa
Question 2
In a concentric spring of same length the ratio of the outer spring diameter to the inner spring diameter is 2 and assume the same spring index, the ratio of the outer spring force to the inner spring force is
Question 3
Which of the following boiler accessories utilizes the waste heat of flue gases to heat the feed water?
Question 4
For a rake angle of zero degree, the given cutting force= 500 N and thrust force = 400 N. What is the value of normal force(in N )on the tool rake face?
Question 5
Determine the resistance coefficient of the venturimeter, if the Actual and Theoretical discharges are 10.2 m3/s and 10.86 m3/s respectively.
Question 6
Which of the following shows the range of poisson’s ratio for isotropic elastic solid ______.
Question 7
Which dimensionless number does not depend on flow parameters
Question 8
When two gears are mating each other then which of the following statement about gearing profile is TRUE
Question 9
Choose the wrong statement about the regenerative vapour power cycle employing bled steam form feed water heating:
Question 10
Figure below shows, a reversible heat engine interacting with 3 thermal reservoirs. Then thermal efficiency of heat engine
- 666 attempts
- 1 upvote
- 2 comments
Tags :
ESE & GATE MEGeneralApr 22ESE & GATE ME