Time Left - 15:00 mins
GATE 2023 || Manufacturing & Engineering materials || Quiz 64
Attempt now to get your rank among 61 students!
Question 1
Which of the following assumption are taken during forming in slab method?
Question 2
In a rolling process, thickness of a strip is reduced from 4 mm to 2 mm using 300 mm diameter rolls rotating at 100 rpm. The velocity of the strip (in m/sec) at the neutral point is __________.
Question 3
A 20 mm thick plate is rolled with identical rolls of 400 mm diameter to reduce its thickness to 5 mm. If the friction coefficient at the work-roll interface is 0.15, then minimum number of passes required is
Question 4
If the blank thickness is reduced to half and width of stock is doubled, then the ratio of new bending force to the original is __________?
Question 5
In an extrusion process, let R=extrusion ratio and r=fractional reduction in the area.
The correct relation between R and r is :
Question 6
In a extrusion process billet having diameter 550 mm is extruded, where. The extrusion force required is 35 MN. diameter of extrusion (mm) is? (Extrusion constant = 200 MPa)
- 61 attempts
- 0 upvotes
- 0 comments
Jul 14ESE & GATE ME