Time Left - 15:00 mins
Forging and Wire Drawing - II Starter Quiz
Attempt now to get your rank among 283 students!
Question 1
Which of the following type of stresses is induced in the wire drawing operation?
Question 2
Which of the following forming operation is always a cold forming?
Question 3
Barelling defect in open forging can be removed by ____.
Question 4
A rectangular bar of length, width and height as 2L, b and h respectively is open forged. It sticking is to occurs, the stickling length is given by _______________.
(μ = coefficient of friction).
Question 5
A floating mandrel is used in ____.
Question 6
In a wire drawing operation, diameter of steel wire is reduced from 10 mm to 8 mm. The ideal force required for drawing (ignore friction) is 8.97 kN. The mean flow stress in MPa is ________.
Question 7
A material is being wire drawn , the power law behavior for which is expressed as σ=50ε0.3. The maximum strain in the material per pass in an annealed condition, correct to two decimal places is ___________.(Assume no friction and back pull.)
- 283 attempts
- 0 upvotes
- 0 comments
Jun 20ESE & GATE ME